Build Your Own Arcade Controls Forum

Main => Project Announcements => Topic started by: newtrix on March 20, 2025, 12:30:34 am

Title: Picked up a new project 3-Koam Zback rough.
Post by: newtrix on March 20, 2025, 12:30:34 am

Need ideas. Working Monitor Jamma harness power supply.  No PCB.  Not sure how to finish.  Replacement PCB seems too expensive.  Not sure iif Pandora can work on a real arcade monitor.  Was thinking of a Street Fighter I Championship theme.  I have done mame, Raspberry Pi, Pandora and 60 in 1.  How would you bring it back with a$300 max budget including graphics t-molding and paint?

Title: Re: Picked up a new project 3-Koam Zback rough.
Post by: jeremymtc on March 20, 2025, 10:15:22 pm

J-PAC and a cheap/free PC with VGA. Spend the rest on finishing materials.

Title: Re: Picked up a new project 3-Koam Zback rough.
Post by: newtrix on March 21, 2025, 06:07:14 pm

Did a little initial repair replaced the entire backside.

Title: Re: Picked up a new project 3-Koam Zback rough.
Post by: newtrix on March 23, 2025, 11:13:19 pm

And the front, I ended up cutting off the bottom  2 3/4 inches due to water damage. Then I built a pedestal like a Taito cabinet to restore the height.

Title: Re: Picked up a new project 3-Koam Zback rough.
Post by: jeremymtc on March 27, 2025, 12:31:41 am

Nice going on the repair work! Have you decided what's going into it yet?