Build Your Own Arcade Controls Forum

Main => Software Forum => Topic started by: Wavfact on January 13, 2025, 07:09:23 am

Title: LEDBlinky - GenLEDBlinkyInputMap issues
Post by: Wavfact on January 13, 2025, 07:09:23 am

When setting up my buttons and ports, everything works fine till I get to port 49, after that, RED and BLUE are reversed..  The button lights up blue when it is set to RED.. and shows RED when the button is set to blue..  GREEN is fine..  I checked my wiring all all is correct.  Is this an LEDBlink issue? or am I missing something?

Title: Re: LEDBlinky - GenLEDBlinkyInputMap issues
Post by: Fursphere on January 16, 2025, 10:49:06 pm

Thats because the wiring is flipped on the other side of the board.

If the button lights up BLUE, set the config map to BLUE.  Trust your eyes! 

I was literally just setting this up on my four player setup like 10 minutes ago.  lol   Good timing.  :cheers: