The NEW Build Your Own Arcade Controls
Main => Main Forum => Topic started by: midd on December 14, 2024, 05:49:22 pm
-
about a month ago, I tried xinput mode on my ipac. I was trying to get a game to run with it. Having no luck, I switched back to keyboard mode and since then, I have had no use of my buttons or controllers.
I tried a different ipac with the same results. So it's leading to me to believe its a wiring issue. Not long before that I added 5 more gold leaf buttons to replace regular LED buttons that I never had the leds wired for.
Now here's where it gets weird, I get switch to xinput and dinput mode by holding down the buttons. But I can't switch back to keyboard unless I load the ipac config file. Ive been using keyboard test to see if there is any response. When I move player 1 controller around, the shift values are shown instead of the primary value. up is grave, right is tab and left is enter. down isnt registered. I don't have any key assinged as the shift key. and only 2 buttons are recognized but they are not what they are assigned to in Winpac.
-
I think it’s the last couple of gold leaf buttons that I purchased. When I run a new ground as test, the proper value goes off immediately upon connecting it. But nothing happens when I tap on them even with the ground.
-
Clean the contacts?