Build Your Own Arcade Controls Forum

Main => Main Forum => Topic started by: mamemia on June 04, 2002, 02:07:03 am

Title: new Joyboards
Post by: mamemia on June 04, 2002, 02:07:03 am

Hi
I am a German Mame Fan, and i build my Controls with a SNES-Topfighter Joybords, here some new Projects:
(http://oliver.hasler.bei.t-online.de/dkonk02.JPG)

Gru

Title: Re: new Joyboards
Post by: mamemia on June 04, 2002, 02:25:13 am

Work with Plexi-Glas (4mm) ... ;) and the Stick are orginal nintendo :)
(http://oliver.hasler.bei.t-online.de/dkong01.JPG/)

Title: Re: new Joyboards
Post by: Carsten Carlos on June 04, 2002, 02:37:26 am

Whee, these look really good!  :D :D
How did you made the overlay-printings? Glossy-paper? Or is it directly reversed-printed on the plexiglas itself?

Carsten, also from Germany ;)

Title: Re: new Joyboards
Post by: mamemia on June 04, 2002, 04:11:28 am

The Overlays was printing on Transparent Inkjet Labels from Zweckform No.4723 (Din A4), und werden Seitenverkehrt gedruckt, anschlie

Title: Re: new Joyboards
Post by: Carsten Carlos on June 04, 2002, 04:34:18 am

Thanx, even with article-number - I'll have a look at these  :D
Guess this transparent labels could also be a good idea for making a marquee. Printing directly on plexi/Lexan is quite expensive (about 100 Euro / $90).

This controls are sure a lot of fun to play with!

Title: Re: new Joyboards
Post by: delta88 on June 04, 2002, 06:19:36 am

F.Y.I

those stix with the black knobs are not original nintendo joysticks.......  nintendo joystix have a very short shaft.
if you need a pic say so..I have a few nintendo cabs and a joystic that I can take a pic of for ya :)

d88

Title: Re: new Joyboards
Post by: 1UP on June 06, 2002, 05:43:05 pm

Quote

The Overlays was printing on Transparent Inkjet Labels from Zweckform No.4723 (Din A4), and if side-twisted are printed, afterwards the printed side(page) is pasted with white DcFix. Then the finished sticker is stuck from below on the Perspex disc etc... ;)

Okay, I had to re-translate that last part, looks like something got lost after (Din A4)!  So it sounds like you reverse-printed on clear adhesive sheets, sprayed (?) the backside with some kind of white fixative to fix the ink and make it opaque, then stuck them to the bottom of the plexiglass.  Has anyone tried having a print shop print something on adhesive film?  Just wondering what the cost would be...

Title: Re: new Joyboards
Post by: mamemia on June 12, 2002, 10:54:16 am

NEW!! Asteroids Panel ;-)
(http://oliver.hasler.bei.t-online.de/ast02.JPG)

Gru

Title: Re: new Joyboards
Post by: Carsten Carlos on June 12, 2002, 11:54:15 am

I really like your joyboards! Looks like loads of fun! :D

Should have seen these before, maybe then I would build only small controlpanels, too, instead of this big and unbelievable expensive upright-cabinet! ;D ;D ;D