Build Your Own Arcade Controls Forum
Main => Main Forum => Topic started by: Locke141 on June 12, 2023, 09:23:07 pm
-
My restore of an old Nintendo cabinet into a multi 4way joysticks games is it good and pretty close to done. So starting to think about using the CNC, I have access to to do a few bartop.
Was thinking about the spray, painting, the body red, and using my vinyl cutter to make a white vinyl sticker for the sides. Does anyone know if there is an existent set of plans? The internal motherboard will be original.
In the picture below, I took from a design four full size and just took a photo of the section I'm looking for. Was thinking maybe extend the body to better support the Control panel.