Build Your Own Arcade Controls Forum
Main => Main Forum => Topic started by: Oldskool on February 27, 2004, 07:54:36 pm
-
The parts list for the "2-Way, 4-Way, 8-Way Replacement Stick" calls up two switch actuators.
One is used for 2 and 8 way use (.600" diameter), and the other is used for 4-way use (.500" diameter)
I only received the .600" with my stick.
The model number is 15-9653. Should I have received both?
Where can I get a .500" ?
This is probably something that I can make, but I was just wondering.....
Thanks in advance.
-
They never come with both. :( Mine didn't either. The instruction sheet is misleading as I thought I was missing one too. Talk about cheap >:(. I mean how much could it cost to throw in both actuators ? Maybe another 3 cents ? ::)
-
Maybe another 3 cents ? ::)
Not even...... :(
-
I'd be hard pressed to believe Wico sold these for more than $5 each when new, so I'd likely attribute them leaving out the other actuator up to penny pinching. Then again, the other actuator is useless for a given stick, so there would be no good reason to include it as it'd likely just be tossed in the trash by the service techs.
If you can scare up a Wico rebuild kit, they come with both actuators.
-
Are you going to be using yours for 4-way action only? If so, I have the .5 actuator but I need the .6. If you only need 4-way action then I'd be more than happy to trade with you.
-
then I'd be more than happy to trade with you.
Excellent.
A PM is on the way....