The NEW Build Your Own Arcade Controls
Arcade Collecting => Merit/JVL Touchscreen => Topic started by: leafundersocre on November 27, 2021, 01:37:55 am
-
Hello there!
Quite a while ago I got a bunch of Megatouch, Touch Master, and 1 JVL iTouch 6 machine.
I have gotten the others all up and working so far except the iTouch 6. All hardware is finally up and working. I have the iTouch 6 key with an iTouch 6 Plus V2.0D CD. I am receiving an error that says Machine Locked - Invalid EEPROM - Call Operator.
When pushing the settings button on the I/O board or in the coin door a screen pops up allowing me to enter a PIN along with a serial number across the top. I have gone through the whole system and only have 1 EPROM and that's the Datalight chip containing the dos boot stuff. I did change that out with a different one just to squash that as an issue.
I've also tried booting without the key thinking that was the issue being greeted with a no key present message. I tried a new CF and on boot the software was installed on it with the same outcome.
Any clue what EEPROM that is invalid that it's speaking of? Is iTouch 6 Plus not valid with the iTouch 6 key? I can't seem to find a copy of the iTouch 6 V1.0 software to try that.
Thank you in advance for any help! :)
-
Does this machine boot from CD or CF card? Can you make an ISO of the CD and image of the CF card and send me a copy? I will try to replicate on my machine