Build Your Own Arcade Controls Forum

Main => Monitor/Video Forum => Topic started by: ninjitsu12 on August 14, 2021, 12:29:26 am

Title: swap hd 4850 video card for hd 5450, do I have to configure groovymame again?
Post by: ninjitsu12 on August 14, 2021, 12:29:26 am

Hello friends, I have a doubt, my video card is an HD 4850, but it burned, and I wanted to put a HD 5450 in its place.
my doubt i have groovymame and retroarch, putting this new video card will i have to configure retroarch and groovymame all over again after installing crt emudriver?
thanks

Title: Re: swap hd 4850 video card for hd 5450, do I have to configure groovymame again?
Post by: buttersoft on August 15, 2021, 07:16:29 am

Probably... not.

You should go into VMM and enable EDID emulation, at least. But I think it should just load up and work. I've certainly done similar in testing.

Title: Re: swap hd 4850 video card for hd 5450, do I have to configure groovymame again?
Post by: ninjitsu12 on August 15, 2021, 05:55:21 pm

ok buttersoft i'll try thanks