Build Your Own Arcade Controls Forum
Main => Main Forum => Topic started by: Ap1 on March 25, 2021, 06:25:00 pm
-
What's the best way to mount defender joystick in metal control panel? I'm concerned about the height of the joystick and how would I compensate for that?
I have not had any luck searching for this answer.
-
Are we talking about an original 2 way or a zippy with a two way restrictor plate?
-
What's the best way to mount defender joystick in metal control panel? I'm concerned about the height of the joystick and how would I compensate for that?
Pack the panel out to a thickness of 21mm to match the Williams Defender panel.
-
Are we talking about an original 2 way or a zippy with a two way restrictor plate?
No a repro original from Arcadeshop I guess although I was looking at Zippy's and the GGG Leaf-Pro™ True Leaf-Switch Joystick. Not many other solutions I can find. Thank you Vocalitus
Pack the panel out to a thickness of 21mm to match the Williams Defender panel.
Ahh so a piece of 3/4 plywood is 18.0086mm here in the states. So I need to find something 3mm thick to stack on top for a proper height. Jimmer is there a template to cut out such a mounting?
Edit: I'm more asking about the hole size in the metal panel itself. What's the best way to cut this out? Is it with a Dremel and cut wheel?
Thanks
-
The same joystick was used in Stargate 19mm panel, by putting the washer in a different position, see attached.
18mm ply plus your 2mm? metal panel would be OK with the Defender setup. A bit high is better than a bit low.
Something like 12mm x28mm for the panel hole.
-
Thank you very much for a great post!