Build Your Own Arcade Controls Forum
Main => Main Forum => Topic started by: San on December 13, 2020, 08:22:48 pm
-
Hi everyone,
Hoping someone can help me out. I am looking to integrate a MagStick Plus in to my arcade cabinet, but I can’t seem to find a wiring diagram for a Reyann/EasyGet USB encoder. I will be using retropie, but I am hooking the USB encoder into a Windows box just to test the buttons and joystick calibration.
Thanks,
-
Isn't that just another name for the Zero Delay encoders? If so, here ya go: https://images-na.ssl-images-amazon.com/images/I/71LFCa7R6uL._AC_SL1500_.jpg
They're detected as gamepads/joysticks in windows so it's also very easy to test. Plug into a computer, hook up a button, go to "Devices and Printers", right click the Zero Delay controller and choose Game Controller Settings, Click properties, and you'll see a little screen where you can preview each of the buttons pushed and what windows labels them as. I've attached what it looks like for an Xbox controller.
Good luck!
-
I can’t seem to find a wiring diagram for a Reyann/EasyGet USB encoder.
How about this one?
- Use the 2Pin Joystick connectors hooked to the NO (Normally Open) and COM (Common) tabs on the Mag-Stick microswitches.
(https://images-na.ssl-images-amazon.com/images/I/71LFCa7R6uL._AC_SL1500_.jpg)
- Remember that the actuator moves opposite of the handle so if you push the handle right, the actuator presses the switch on the left.
(http://wiki.arcadecontrols.com/images/thumb/6/6e/Stick-principal.jpg/300px-Stick-principal.jpg)
Scott