Build Your Own Arcade Controls Forum

Main => Main Forum => Topic started by: duyvh0309 on July 15, 2020, 04:21:21 am

Title: Dynamo cab control panel thickness
Post by: duyvh0309 on July 15, 2020, 04:21:21 am

Góc chia sẻ: "Những mặt hàng nên mua trên Amazon". Xem tại : https://basso.vn/nhung-mat-hang-nen-mua-tren-amazon.html
Hướng dẫn cách mua hàng trên Amazon bằng Gift Card. xem tại : https://basso.vn/cach-mua-hang-tren-amazon-bang-gift-card.html
Cách tính thuế khi mua hàng trên Amazon . Xem tại : https://basso.vn/cach-tinh-thue-khi-mua-hang-tren-amazon.html

Title: Re: Dynamo cab control panel thickness
Post by: mahuti on July 16, 2020, 04:38:10 am

I have a dynamo cab but recently gave away the metal control panel, so I cant give you specific measurements. So until someone else chimes in with details, I recall the metal being really really solid. I'd guess 1/8" thickness... thin enough to accommodate snap-in buttons, but near impossible to bend by hand without tools. 

Title: Re: Dynamo cab control panel thickness
Post by: Lamonsoff on July 19, 2020, 12:49:00 pm

It’s closer to 1/16” thick. I recently had mine welded up for a Street Fighter button layout

Title: Re: Dynamo cab control panel thickness
Post by: Howard_Casto on July 19, 2020, 04:52:20 pm

Quote from: duyvh0309 on July 15, 2020, 04:21:21 am

I’d like to build a dynamo replica cab from scratch.
I was able to get some measurements from the internet about the dimensions (width, height, etc), but I don’t find the thickness of the metal sheet. Does anyone know this?
HS-1 corner cut panel thickness?

Unless you have a professional metal worker at your disposal it would be much easier to recreate it out of wood.... the way the control panels are designed you won't be able to tell the difference once you put an overlay on it.