The NEW Build Your Own Arcade Controls

Software Support => GroovyMAME => Topic started by: dabone on May 06, 2020, 11:54:45 am

Title: Crtemu Driver win 7, Hide Modes that the monitor cannot display
Post by: dabone on May 06, 2020, 11:54:45 am

I've got a win7 box, radeon r7-260 loaded up with CRTemu driver 2.0 beta 15, and all the modes seem to run correctly, but I can't get Hide Modes that the monitor cannot display to stay set.

For Monitor presets I have a WG25k7131 set, and edid emulation enabled on VGA (It's a DVI-I port, but when I enable on the vga, it does swap to the correct 15k mode)

When I go to display settings, advanced, monitor, the Monitor shows as a Generic PNP Monitor, and I can check the Hide modes button,
Then I can start emulationstation in 15k, but after a restart the setting is unchecked so emulationstation starts in 31k.

Any suggestions?

The setup is running all my emulators correctly.

Thanks.
Later,
dabone

Title: Re: Crtemu Driver win 7, Hide Modes that the monitor cannot display
Post by: alex2005 on May 06, 2020, 01:16:00 pm

Have you disabled completely the AMD External Events Utility service?

Title: Re: Crtemu Driver win 7, Hide Modes that the monitor cannot display
Post by: dabone on May 06, 2020, 01:29:08 pm

Thanks! That was it, I knew I had to be missing something easy.
Working fine now.

I used to have a link to a great walkthru for installing crtemu driver under windows, but I can't seem to locate it at the moment.

Next question, where is the right place to ask questions on atom 15?

Thanks again.

Later,
dabone