The NEW Build Your Own Arcade Controls
Arcade Collecting => Merit/JVL Touchscreen => Topic started by: costanza on November 14, 2019, 03:03:14 pm
-
Hello All! This is my first post.
So I had an interesting issue last night. My MegaTouch GameTime (think it's a consumer version) wouldn't POST or boot. Checked the power supply and voltages were good. Checked to make sure everything was plugged in, reseated a few things but still no joy. What I wound up doing was adding a couple jumper wires (to use as a switch) to the mother PWRON jumpers and low and behold it booted.
This seems strange to me. What would prevent it from posting or booting? If there wasn't a switch there before...why does it all of a sudden need one? How was it configured to boot before when all that needed to happen was flipping the switch in the back to powerup the power supply.
-Costanza
-
Bios battery is dead. Replace battery, plug in a keyboard, hit DEL to get into bios, go under power managment and look for a setting that says after power loss and set it to power on after power loss.
You're welcome.