Build Your Own Arcade Controls Forum
Main => Software Forum => Topic started by: Nylkos on February 12, 2019, 07:48:35 pm
-
Hi, I used to play a lot of Roms, stopped about 14 years ago (first kid), but the switch and it's free retrogaming had me hooked again.
I am planning to build an arcade cabinet with light-guns (I still own 2 Guncon 2 and 1 Guncon). ATM I do own a Raspberry Pi B+, a few old PC and a CRT TV.
In other terms I am equipped to go in most directions, but I would like to use what I have.
I am posting this because I did a lot of research and found a lot of different info about Guncon and some time I am even unsure if it'S for PC, Raspberry Pi or anything else.
So far:
- I found the Windows 10 drivers in the following thread: http://forum.arcadecontrols.com/index.php?topic=154492.0 (http://forum.arcadecontrols.com/index.php?topic=154492.0) which allow me to shoot at my icons, but haven't found how to use it with Attract Mode
- I was unable to find the required drivers for Linux.
Does anyone have a link about how to use such light guns from beginning to the end?
Thank you
-
I tested with Demul and some dreamcast games that I already own.
Sadly and strangely, in both case, the cursor is in the right spot (where I am aiming), but I when I shoot it hit a few cm to the left...
Anyone wknos how to fix this issue?
-
So are you using a EMS TopGun?
-
So are you using a EMS TopGun?
No, I am using a Windows 10 driver made from a forum member, the link is in my first post.
Like mentionned the issue that I have is the cursor is well calibrated, but when I shoot it doesn't shoot on the cursor, it shoots a few cm to it's left...