Build Your Own Arcade Controls Forum
Main => Main Forum => Topic started by: Azirithdorr on October 16, 2018, 12:21:45 pm
-
Hi all, thanks for reading!
Just recently got back into my arcade, and replaced my Ultimarc IPAC-2 with a Ultimate I/O. Did a fresh install of Launchbox and Retroarch.
Things are going pretty good, but one nagging thing that is happening is when I boot up an emulator, I get the following message:
"100%: I-PAC Ultimate (53769/140) not configured."
From what I've been able to find, the advice is "go into Retroarch and shut off the warning". Do you agree with this? I'm curious what the warning even means.
The only other thing I've noticed is that only a few of my LED buttons are lit up once I'm in Launchbox. When I boot the PC, all the LEDs fade up and down in the preset pattern ( built into the Ultimate I understand ). But once in the frontend, only a few are lit and that's constant with no change - even after exiting the frontend. Could the error be related to this?
Again, thank you very much for reading and any responses - I appreciate it :>
-
I just got the i-Pac Ultimate for my LaunchBox setup and will be installing as soon as I get my graphics back. I have done a couple of Hyperspin builds with the Ultimate using Rocketlauncher and have never come across this message nor have I come across this message with the old i-Pac 4's with the LEDPac64 controller. Is this a LaunchBox only thing?
-
I'm not sure - could be. I've only seen it when using Launchbox, but then again, that's all I use right now.