Build Your Own Arcade Controls Forum

Main => Main Forum => Topic started by: Gryizor on February 19, 2018, 05:14:12 pm

Title: Electric ICE 2-CX (Micro-Leaf) buttons with IPac2 - wiring questions.
Post by: Gryizor on February 19, 2018, 05:14:12 pm

Hi all,

I hope someone in here can help me:

I recently ordered a LED-Wiz and  Electric ICE 2-CX (Micro-Leaf) buttons from GroovyGameGear, and a separate IPac2 for a pinball project.

The buttons have all been hooked up with LED-Wiz and all lights are working fine. I am however in doubt how to connect the Micro-Leaf buttons to the IPac2 since all of them come with three pins (and not two like Sanwa buttons for instance) for connection with the spade/crimp-wire.

Looking at the Micro-Leaf switch, I can see the pins having the numbers 1, 3 and 2.

Can anyone tell me which of the three pins should be used for connecting with the IPac2 and which one should be used for "Ground" ?

Thanks.

Title: Re: Electric ICE 2-CX (Micro-Leaf) buttons with IPac2 - wiring questions.
Post by: PL1 on February 19, 2018, 05:53:30 pm

Teminal tabs on the MicroLeaf: (left to right)

Normally Closed (NC)  Normally Open (NO)               Common (COM)

(http://groovygamegear.com/webstore/images/medium/ML1_MED.jpg)

Connect NO to the I-Pac input and connect COM to the daisy-chain ground.

The NC tab is *usually* not used.


Scott

Title: Re: Electric ICE 2-CX (Micro-Leaf) buttons with IPac2 - wiring questions.
Post by: Gryizor on February 20, 2018, 04:25:16 pm

@PL1: Thank you, this was exactly what I needed. Much appreciated.