Build Your Own Arcade Controls Forum

Main => Audio/Jukebox/MP3 Forum => Topic started by: jefferson1975 on February 19, 2018, 11:08:06 am

Title: Rowe record selection issue
Post by: jefferson1975 on February 19, 2018, 11:08:06 am

Hello,

I have a Rowe R-83. Whenever I choose record 127/227 it always goes to 128/228. Every other record selection is fine. Any thoughts on what is causing this issue?

Thanks!
Jeff

Title: Re: Rowe record selection issue
Post by: ami-man on February 27, 2018, 05:47:00 am

Hello Jeff,

If all the other selections are fine I would be looking at the encoder printed circuit board for any defects at that location.

Regards
Alan

Alan Hood
ami-man
UK

Title: Re: Rowe record selection issue
Post by: jefferson1975 on February 28, 2018, 10:38:02 am

Thanks Alan. I'll take a look. On a side note, I currently have a 1200 mechanism tonearm in my Rowe R-83. I'd like to get the correct 125 watt amp. However, the phono/amp cables are different for the 125 amp. Mine has the round plug on the tonearm and the Left/Right RCA plugs into the amp.  Is there any way to use my current 1200 mechanism tonearm with the 125 watt amp?

Thanks!
Jeff

Title: Re: Rowe record selection issue
Post by: ami-man on March 26, 2018, 08:30:25 am

Hello Jeff,

You have to remove the phono connection on the loom and fitt a three pin connector. The cartridge connections have to be changed so there are in phase, they will be wired out of phase currently.

Regards
Alan

Alan Hood
ami-man
UK