Build Your Own Arcade Controls Forum

Software Support => GroovyMAME => Topic started by: joeblade2 on April 15, 2017, 12:02:40 pm

Title: Microvetec Monitor issue
Post by: joeblade2 on April 15, 2017, 12:02:40 pm

Hi Guys, so decided to put my GM setup on my microvetec monitor, very little info exists on this monitor.

(https://image.ibb.co/gsKVRQ/Microvitec_monitor.jpg) (https://ibb.co/cdhjmQ)

Running it in Generic mode VMMAKER, arcade_15 in mame ini.

Running into right edge squish and picture being off to the right and only taking up 2/3 of screen on a few games, most are fine!!

Have attached a couple of offenders:

Title: Re: Microvetec Monitor issue
Post by: joeblade2 on April 24, 2017, 04:34:45 pm

Hi guys, I know this hasn't been answered but just thought I'd put up another odd sizing issue i've just found...

Any help would be greatly appreciated on this fellas! :bump

Title: Re: Microvetec Monitor issue
Post by: Calamity on April 24, 2017, 05:31:46 pm

Please use latest GM version. I suspect this issue was already fixed.

EDIT: I'm seeing the scaling options on mode switch was fixed in 0.016 alpha 5, the exact version you're using, so I'm not sure what's going on.

Title: Re: Microvetec Monitor issue
Post by: joeblade2 on April 30, 2017, 07:19:59 pm

Quote from: Calamity on April 24, 2017, 05:31:46 pm

Please use latest GM version. I suspect this issue was already fixed.

EDIT: I'm seeing the scaling options on mode switch was fixed in 0.016 alpha 5, the exact version you're using, so I'm not sure what's going on.

Well if you don't know then it's probably not solvable Calamity.

Will upgrade to newer, older version of everything at some point and see if that fixes anything. :dunno