Build Your Own Arcade Controls Forum
Main => Monitor/Video Forum => Topic started by: mclovin on December 26, 2016, 07:29:09 pm
-
I have a monitor chassis I just capped. Think it's a wgk7500 everything is good and clear, I would just like to make an adjustment as the monitor does not seem plumb for a lack of a better word. The picture needs a slight adjustment counter clockwise. I'm not sure what this adjustment is called, but is it possible to adjust the picture slightly clockwise or counter clockwise? Thanks
-
do you mean the whole picture needs to be slightly rotated to make it square -you would need to rotate the deflection yoke fractionally
-
Yes exactly. I have not done that before, I'll give it a try. Thanks
-
and do it very very slow
or get ready to re converge
ed
-
Ok I had a closer look and it is only the bottom part of the screen that is not running true, I also have a bit of a pincushion issue on the one side in order to get it perfect. I'll Attach a pic.
-
do you have the small daughter board attached,it has a pincushion and traspezoid control
-
+1. I had a similar issue. I called the guy I bought it from and he told me where the trapezoid adjustment was.
Mine is not a WG, otherwise I would post a pic of the location.
-
do you have the small daughter board attached,it has a pincushion and traspezoid control
Yes, tried adjusting the pots and no real change that I could see.