Build Your Own Arcade Controls Forum
Main => Software Forum => Topic started by: bcgamer on November 15, 2016, 07:12:23 pm
-
Why is model2 doing this all of a sudden
Load game- loads no problem
Go up to game/config control
Emulator crash.
Every time. Yesterday wasn't an issue.
I'm using the multicpu version.
Tried both, no dice same thing.
-
Do you have more than one controller connected?
-
Yes I have 2 Xbox 360's
I'm taking that's the issue?
Should the 2nd be off when setting them?
-
Could be. Just trying to get more info.
People have reported that happening when they have a wheel and other controllers connected.
You can map all the controllers, but have to do them separately, one at a time. Then plug them all back in and run the game.
If those 2 Xbox controllers are the only ones you are using, xinput should be enabled in the cfg file.
-
What I've done is take a separate build and did them again
I'm setting up model 2 racing games in HS for multiplayer so I need to have multiple copies of the emulator and set slave/controls for each one
Seems to be getting along for the most part now...