Build Your Own Arcade Controls Forum

Main => Main Forum => Topic started by: fablog on September 17, 2016, 10:42:19 pm

Title: Connect 2 U360 to an Ipac UIO
Post by: fablog on September 17, 2016, 10:42:19 pm

I would like to know how to wire my U360s in output mode to an Ipac360.  would someone share a picture please?   Do I have to use these wires included with the UIO? Modify them? I'm really not a genius for all about wiring :)

Title: Re: Connect 2 U360 to an Ipac UIO
Post by: fablog on September 21, 2016, 06:41:18 pm

Well, it seem's nobody could answer my questions...  :(
For those wondering the same thing, I answered to my own questions. I cut the end of the wires included with the Ipac UIO and used a molex connector  instead. You have to connect only the Up, Down, Left and Right pins If you keep connected with a USB cable. So power and ground wires are useless in this case.
I have to say that it's night and day in Hyperspin and emulators. No more weird reactions and much more easyer to configure!