The NEW Build Your Own Arcade Controls

Main => Main Forum => Topic started by: fastredpacman on June 13, 2016, 02:29:37 pm

Title: need help removing coin door
Post by: fastredpacman on June 13, 2016, 02:29:37 pm

I have a dynamo cab that I need to remove the over under coin door. I tried looking up a guide but no luck. New to this so could use some advice if you have a guide with pictures even better. Thanks!

Title: Re: need help removing coin door
Post by: harveybirdman on June 13, 2016, 02:54:18 pm

Unscrew the brackets, I tried to make it harder than it was my first time as well.

Title: Re: need help removing coin door
Post by: lilshawn on June 13, 2016, 02:57:49 pm

there are a bunch bolts holding down clips all the way around the inside perimeter of the door.

grab a nut driver, remove all the bolts/clips and the door will basically fall out.

not much to it.

Title: Re: need help removing coin door
Post by: harveybirdman on June 13, 2016, 03:01:10 pm

yep added a picture for reference.

Title: Re: need help removing coin door
Post by: yotsuya on June 13, 2016, 03:01:46 pm

There are these little clips around the edges of the door. Loosen them with a ratchet.

Sent from my SM-G386T using Tapatalk

Title: Re: need help removing coin door
Post by: harveybirdman on June 13, 2016, 03:02:36 pm

Quote from: yotsuya on June 13, 2016, 03:01:46 pm

There are these little clips around the edges of the door. Loosen them with a ratchet.

Sent from my SM-G386T using Tapatalk

Your Scott-FU is slipping.... Too much solder fumes....

Title: Re: need help removing coin door
Post by: yotsuya on June 13, 2016, 03:02:43 pm

Looks like I picked the wrong week to stop sniffing glue...

Sent from my SM-G386T using Tapatalk

Title: Re: need help removing coin door
Post by: fastredpacman on June 13, 2016, 09:22:37 pm

Wow seems easy, thanks for the help!!