Build Your Own Arcade Controls Forum

Main => Monitor/Video Forum => Topic started by: Vincefaro on April 14, 2016, 12:13:21 pm

Title: Possible neck crack help on D9200
Post by: Vincefaro on April 14, 2016, 12:13:21 pm

I'm trying to diagnose a problem
With a wells Gardner D9200 that is not working I keep frying  neck boards . I have a new chassis and neck board but Chad from arcade cup said I may have a fracture in the neck , the only thing I see is a scuff right by the white tape that is by the two holes in the tape . Could that be it ?

Title: Re: Possible neck crack help on D9200
Post by: Vincefaro on April 14, 2016, 12:14:44 pm

Another

Title: Re: Possible neck crack help on D9200
Post by: grantspain on April 14, 2016, 06:25:27 pm

what components were burning out?

Title: Re: Possible neck crack help on D9200
Post by: Vincefaro on April 15, 2016, 11:25:10 am

The g2 pin on the neck board .

Title: Re: Possible neck crack help on D9200
Post by: ed12 on April 15, 2016, 11:36:11 am

grid 2 ?

ed

Title: Re: Possible neck crack help on D9200
Post by: lilshawn on April 15, 2016, 02:39:08 pm

maybe an internal G2 short. possibly fixable with a rejuvenator.

could also just be a bad/corroded/lose connection on the pin caused overheating and localized burning.

cracked necks are usually pretty obvious. I highly doubt this is your issue.

Title: Re: Possible neck crack help on D9200
Post by: ed12 on April 15, 2016, 05:03:15 pm

well i was leading towards a short..
just want to get to the how the @ came up with g2?

ed

Title: Re: Possible neck crack help on D9200
Post by: Vincefaro on April 15, 2016, 08:55:09 pm

I think a short is good news , not a cracked neck yes?  Any suggestions for troubleshooting?

Title: Re: Possible neck crack help on D9200
Post by: ed12 on April 15, 2016, 10:12:30 pm

olny a person with a picture tube chker can now tell u.
short good,crack neck no good

ed