The NEW Build Your Own Arcade Controls
Main => Monitor/Video Forum => Topic started by: basscadet on March 05, 2016, 04:44:28 am
-
Hi all,
I have a setup that uses a Hantarex Polo 25 monitor and I'd like to make a harness to get that remote adjustment board out of the box and make it, well, remote. Thing is, I have no idea what kind of connectors I should look for. It's a 16-pin connector with flat pins (15 are actually connected). I'd also like to find some of those plastic tools on the trim pots that are missing (you can see the one in the center of the adjustment board, and there's four missing from the board at the back of the monitor screen). Any ideas?
(http://i.imgur.com/AWm4POA.jpg)
-
those connectors have not been available for years,some of the extender cables come up on ebay uk from time to time
a seller on jammaplus has the pot spindles,shafts-whatever you want to call them
-
The trimmer in the middle is bigger and uses a different knob:
http://www.tme.eu/gb/details/pt15gw-12b/trimmers-knobs/piher/5272/ (http://www.tme.eu/gb/details/pt15gw-12b/trimmers-knobs/piher/5272/)
http://www.tme.eu/gb/details/pt15gw-19/trimmers-knobs/piher/5214/ (http://www.tme.eu/gb/details/pt15gw-19/trimmers-knobs/piher/5214/)
http://www.tme.eu/gb/details/pt15gw-35/trimmers-knobs/piher/5209/ (http://www.tme.eu/gb/details/pt15gw-35/trimmers-knobs/piher/5209/)
The other trimmers use this type:
http://www.tme.eu/gb/details/ca9ma5/trimmers-knobs/acp/ca9ma-9005/ (http://www.tme.eu/gb/details/ca9ma5/trimmers-knobs/acp/ca9ma-9005/)
What's the matter with those video input pins??
-
Ok thanks, I guessed those connectors would be discontinued but I thought I'd give it a try.
What's the matter with those video input pins??
Which ones? ???