Build Your Own Arcade Controls Forum

Main => Raspberry Pi & Dev Board => Topic started by: thekaj on September 08, 2015, 12:05:37 pm

Title: U-Trak/I-Pac/Pi with RetroPie Connectivity
Post by: thekaj on September 08, 2015, 12:05:37 pm

I am just getting my Pi powered arcade cabinet up and running, but have run into a snag with the U-Trak trackball.  Everything is running through a Ipac 2, with all the other buttons and joysticks operational, but I'm not getting any response from the trackball.  I did notice that only one of the connectors has a ground wire, but I'm assuming that I'd at least have one directional response.

Does anyone know if there is additional setup required in RetroPie before it recognizes the U-Trak?  I did attempt to change the controls in Centipede, but it wasn't even registering the input.  Any help would be appreciated!

Title: Re: U-Trak/I-Pac/Pi with RetroPie Connectivity
Post by: robboman123 on March 14, 2016, 03:46:16 pm

Me too!  I just posted a new thread, very similar issue on my IPac2. 

Did you fix yours?  (this looks like an old post)

Anyone else have any ideas?