Build Your Own Arcade Controls Forum

Main => Woodworking => Topic started by: brihyn on August 08, 2015, 12:04:45 pm

Title: Panel Layout Software
Post by: brihyn on August 08, 2015, 12:04:45 pm

trying to build 5 OND cabs of varying sizes, I wanted to make sure I minimized the lumber purchased.
I'm sure plenty of people have software for this, but for those that don't, I found MaxCut V2 to do this....really simple software to add in all of the pieces you need, and it'll optimize the cuts for you.

http://www.maxcut.co.za/ (http://www.maxcut.co.za/)

Title: Re: Panel Layout Software
Post by: Zzap on August 09, 2015, 10:04:50 pm

When I saw the title, I went digging through my start menu to find what software I'd been using before reading your message. I thought you were after a recommendation, but after finding I'd been using MaxCut too, I discovered you were recommending it as well ;D

Title: Re: Panel Layout Software
Post by: megamoze on August 10, 2015, 12:51:15 am

I wish I knew about this two weeks ago!   :) ??? :banghead: :applaud:

Title: Re: Panel Layout Software
Post by: otsep on September 07, 2015, 02:41:58 pm

You could also use the CutList extension for SketchUp.

Title: Re: Panel Layout Software
Post by: aDamelGar on October 22, 2015, 03:40:48 am

Have the necessary software for this DIY project lined up before you start.Begin your planning by making of your proposed with add dimensions can estimate.