Build Your Own Arcade Controls Forum

Main => Main Forum => Topic started by: ThePlatypus on March 31, 2015, 05:26:27 pm

Title: U360 ball oval conversion.
Post by: ThePlatypus on March 31, 2015, 05:26:27 pm

I have a set of U360 ovals, can i convert them to ball tops by buying a ball top shaft?

Title: Re: U360 ball oval conversion.
Post by: lamprey on March 31, 2015, 05:53:18 pm

Yes.

Title: Re: U360 ball oval conversion.
Post by: behrmr on March 31, 2015, 07:39:15 pm

I seem to remember the shafts being different in diameter and having a different size thread on them but I could be wrong.  You could always email Andy to make sure.

Title: Re: U360 ball oval conversion.
Post by: lamprey on April 01, 2015, 12:57:54 pm

Quote from: behrmr on March 31, 2015, 07:39:15 pm

I seem to remember the shafts being different in diameter and having a different size thread on them but I could be wrong.  You could always email Andy to make sure.

If you check the Ultimarc website, they sell two different shafts for the U360: Oval (bat) top and Ball top.

Title: Re: U360 ball oval conversion.
Post by: behrmr on April 01, 2015, 01:35:47 pm

Quote from: lamprey on April 01, 2015, 12:57:54 pm

Quote from: behrmr on March 31, 2015, 07:39:15 pm

I seem to remember the shafts being different in diameter and having a different size thread on them but I could be wrong.  You could always email Andy to make sure.

If you check the Ultimarc website, they sell two different shafts for the U360: Oval (bat) top and Ball top.

OK.  I didn't quite understand the OP's question.