Build Your Own Arcade Controls Forum

Main => Main Forum => Topic started by: davijc02 on February 23, 2015, 02:14:17 pm

Title: Ultimarc Trackball and Golden Tee PCB Board
Post by: davijc02 on February 23, 2015, 02:14:17 pm

Recently ordered an Ultimarc Utrak and am wondering if I will be able to connect this two a golden tee pcb and if so how would I go about doing it? Would I just splice the wires of does a harness exist in which I could use?

Thanks

Title: Re: Ultimarc Trackball and Golden Tee PCB Board
Post by: lilshawn on February 23, 2015, 02:31:56 pm

yep, it'll splice right in provided you bought the regular version and not the USB version.

Quote

Conn A Red   5 Volts
Conn A Black   GROUND
Conn A Purple   X1
Conn A Blue   X2
Conn B Red   5 Volts
Conn B Black   GROUND
Conn B Yellow   Y1
Conn B Green   Y2

Title: Re: Ultimarc Trackball and Golden Tee PCB Board
Post by: davijc02 on February 23, 2015, 02:39:53 pm

I did buy the USB version. Think I can use wiretaps to splice in without cutting off the connector?

Title: Re: Ultimarc Trackball and Golden Tee PCB Board
Post by: davijc02 on February 23, 2015, 02:41:30 pm

Also, this unit has two 5v wires and two grounds. I think the Happ that its intended for only had one of each ground and 5v. Would I just splice the two 5v volts together with the 5v wire from the golden tee pcb and same thing with the ground?