Build Your Own Arcade Controls Forum
Main => Monitor/Video Forum => Topic started by: miles2912 on January 17, 2015, 06:33:47 pm
-
I turned on the arcade last night and there was no picture. The pc is outputting a signal so I start to look at the monitor. After removing the back of my cab I see this.
(http://i.imgur.com/FMgUr5S.jpg)
It looks like there was a board attached to this back part...
(http://i.imgur.com/vqOHVm4.jpg)
Looking down I saw the missing board.
(http://i.imgur.com/koBIfvg.jpg)
Another shot of the board.
(http://i.imgur.com/NcWZyXu.jpg)
Does this just plug back in and work. Is there anything special I need to do to re-attach it? I know this is some nasty voltage back here so I want to proceed slowly and ask someone who is more knowledgeable than myself. The monitor is over 10 years old, but was working like a champ up until last night when I first noticed this. Thanks for any help
-
line it up correctly and put it back on,no nasty voltage on a neck card without power-infact no voltage anywhere on that chassis without power