The NEW Build Your Own Arcade Controls

Main => Main Forum => Topic started by: bhille on June 17, 2002, 12:59:37 pm

Title: Oscar Restrictors
Post by: bhille on June 17, 2002, 12:59:37 pm

I was looking to put the Oscar restrictors on my wood control panel.  This setup would be without the mounting plate so I can keep the looks as clean as possible.  I would like to use the pegs so it's wasy to swap.  Have people used the pegs instead of the screw mounts?  Would I be better off getting the screw mounts and finding "finger screws" somewhere?  If so, where?

I would just like to hear how other are using these restictors.

Thanks,

Brian

Title: Re: Oscar Restrictors
Post by: Jakobud on June 17, 2002, 07:55:13 pm

I did the same thing as you. I wanted a clean board with no mounting plate. My cp is wood with lexan overlay. So I have holes in the lexan and the wood. Just use the plate as a drilling template.  Anyways, I am using the pegs and they work just fine. No problems.

jake