Build Your Own Arcade Controls Forum

Main => Everything Else => Topic started by: Slippyblade on December 27, 2014, 01:48:11 am

Title: How to mount bearings
Post by: Slippyblade on December 27, 2014, 01:48:11 am

This is going to sound like a really stupid question, but how the hell do you mount bearings?  I want to build a homebrew spinner/360 wheel.  The encoding part is easy, I get that part.  I truly don't get how to mount the shaft through the bearings on the panel!  I'm thinking I'm going to use Rollerblade bearings, but would consider other ideas. 

Help!

Links or pictures would be best.  Thanks in advance.

Title: Re: How to mount bearings
Post by: Nephasth on December 27, 2014, 10:40:11 am

Most bearings press fit, either onto a shaft (inner race) or into a hole (outer race).