Build Your Own Arcade Controls Forum

Main => Main Forum => Topic started by: MamedInCanada on December 21, 2014, 06:31:14 am

Title: Ultimarc iPAC Led Connection Wiring - connector/molex?
Post by: MamedInCanada on December 21, 2014, 06:31:14 am

What is the connector / molex called that attaches to the header? Anyone have a picture?

Thanks

Title: Re: Ultimarc iPAC Led Connection Wiring - connector/molex?
Post by: AndyWarne on December 21, 2014, 02:35:22 pm

We sell pre-wired LEDs and also pre-crimped wires and connector housings for these.

But they are standard 0.1 inch pitch housings which are widely available.

These for example:  http://www.digikey.com/product-detail/en/65039-033LF/609-2339-ND/1002654 (http://www.digikey.com/product-detail/en/65039-033LF/609-2339-ND/1002654)

Title: Re: Ultimarc iPAC Led Connection Wiring - connector/molex?
Post by: MamedInCanada on December 24, 2014, 01:17:16 pm

Thank-you Andy

     Will this connection work in the below picture? I was able to find a 2 pin connector over? Red over the +5v and black over the ground on the header.

Thanks again

Title: Re: Ultimarc iPAC Led Connection Wiring - connector/molex?
Post by: dkersten on December 28, 2014, 12:39:04 pm

also sometimes called "DuPont connectors" or 2.54mm connectors, if you are trying to search for them on the internet.  And many of the connectors used inside computers are the same size (ie power led and switch, reset switch, usb headers, audio headers, etc)

Title: Re: Ultimarc iPAC Led Connection Wiring - connector/molex?
Post by: MamedInCanada on January 01, 2015, 12:30:27 am

Thanks dkersten...found some on eBay