Build Your Own Arcade Controls Forum

Main => Monitor/Video Forum => Topic started by: mustang on September 12, 2014, 01:26:06 pm

Title: Wells Gardner Help needed
Post by: mustang on September 12, 2014, 01:26:06 pm

Hi
I have a W/G 2792 I bought as a non runner.
I found some tracks burnt and repaired them.


Could some expert on these  tell me please where to look next?

The image is compressed into a vertical strip as you can see.

Many thanks
Martin

Title: Re: Wells Gardner Help needed
Post by: grantspain on September 13, 2014, 05:35:17 am

do you have a photo of the chassis?

Title: Re: Wells Gardner Help needed
Post by: mustang on September 13, 2014, 01:05:55 pm

Here you go Grant:

Title: Re: Wells Gardner Help needed
Post by: grantspain on September 13, 2014, 05:33:05 pm

right so it is a d9200
check out the wg repair guide-"no horizontal scan"
http://www.wellsgardner.com/pdf/Repair/D9200_27_33_39_inch.pdf (http://www.wellsgardner.com/pdf/Repair/D9200_27_33_39_inch.pdf)

Title: Re: Wells Gardner Help needed
Post by: mustang on September 14, 2014, 03:12:48 am

Thanks Grant yes its a 9200.

Would you have a schematic for it?


Martin

Title: Re: Wells Gardner Help needed
Post by: grantspain on September 14, 2014, 04:23:18 am

the schematic is on the wells gardner service site

Title: Re: Wells Gardner Help needed
Post by: mustang on September 16, 2014, 11:45:30 am

Ta