Build Your Own Arcade Controls Forum

Main => Main Forum => Topic started by: wofat on December 02, 2003, 02:03:25 pm

Title: T-Molding - Newbie
Post by: wofat on December 02, 2003, 02:03:25 pm

I know this has been covered but I cant seem to find it.

I am building a console and need t-molding around the edges of my console.  Questions.

How does one make the groove in the particle board? I tried my Dremel on a sample and it takes way too long and the line is not consistent.

Title: Re:T-Molding - Newbie
Post by: Tilzs on December 02, 2003, 02:09:24 pm

Quote from: wofat on December 02, 2003, 02:03:25 pm

I know this has been covered but I cant seem to find it.

I am building a console and need t-molding around the edges of my console.  Questions.

How does one make the groove in the particle board? I tried my Dremel on a sample and it takes way too long and the line is not consistent.

Did you read the FAQ thread that is sticky'd at the top of the board

http://www.arcadecontrols.org/yabbse/index.php?board=1;action=display;threadid=5361

Title: Re:T-Molding - Newbie
Post by: eightbit on December 03, 2003, 10:23:35 am

A router and a slot cutting but.