Build Your Own Arcade Controls Forum

Main => Software Forum => Topic started by: Zeeman on November 29, 2003, 01:56:58 pm

Title: Daphne & ArcadeVGA
Post by: Zeeman on November 29, 2003, 01:56:58 pm

I have an 15hz arcade monitor and the ArcadeVGA card.  When I start Dragon's Lair using Daphne only the top half of the video is being shown.  I'm guessing this is because the video was captured as non-interlaced and is 2x the height I need.  Does Daphne have command switch or something to correct this?  Or do I need to re-encode all the video to get it to work right?  :(

Thanks!

Title: Re:Daphne & ArcadeVGA
Post by: Minwah on November 29, 2003, 05:07:38 pm

I'm not sure 100%, but I seem to remember Daphne has a 'video hardware acceleration' mode or similar.  Try toggling it to see if it makes a difference...

Also, check what resolution Daphne is running in, I'd suggest setting it to 640x480 :)

Title: Re:Daphne & ArcadeVGA
Post by: dreamfreak on December 03, 2003, 03:11:32 am

hi,
I

Title: Re:Daphne & ArcadeVGA
Post by: dreamfreak on December 03, 2003, 01:12:11 pm

hi,
it was the button "disable hardware acceleration (MPEG only)"
now it works fine

thx again a lot to minwah  ;D