Build Your Own Arcade Controls Forum

Main => Buy/Sell/Trade - non-retail => Topic started by: Sarver Systems on November 23, 2013, 10:54:11 am

Title: WTB: Pin extractor
Post by: Sarver Systems on November 23, 2013, 10:54:11 am

Does anyone have a spare laying around they'd want to part with?

I need one for the standard size pins that are used for connecting the CP to the harness for the games that use a pedestal for the control panel.

I also would like to get my hands on a pin extractor for the smaller square pins, like that are used in an ATX power supply.

Title: Re: WTB: Pin extractor
Post by: jennifer on November 24, 2013, 02:38:14 am

    You dont want to waste your money looking for a used one, [they wear out quite fast] and you would be getting the short end of the stick, I wouldnt go with budget either, the thing will fold like a cheap dress... Tyco, makes a nice set, and reasonably priced.

Title: Re: WTB: Pin extractor
Post by: Sarver Systems on November 25, 2013, 12:05:20 pm

I was able to purchase one for $8 at Radio Shack.

Is there a special extractor for the JAMMA connector? If so, can someone provide a link for me?

Title: WTB: Pin extractor
Post by: mgb on November 25, 2013, 12:34:36 pm

(http://img.tapatalk.com/d/13/11/26/5e7yha5u.jpg)Check out Bob Roberts at www.therealbobroberts.net
I think he carries them.
You can really make your own using a paper clip, hairpin or a lead from something like a resistor or cap.

This is what the actual tool looks like.