Build Your Own Arcade Controls Forum
Main => Monitor/Video Forum => Topic started by: DemoMan on November 23, 2013, 09:51:54 am
-
Hi guys/gals. I have a pole position cockpit running a pole position II board. Everything works great but im not getting top speed like I should on the game. Im only getting around 190-195mph. My dip switch settings are correct and set on high speed. When I go into test mode I notice when you push in the accelerator it is reading 60 something. I dont think this is correct. How do I fix this? Is there a throttle pot to adjust on the accelerator itself? Im new to this so if this is the case how do I adjust it? Any help would greatly be appreciated! :)
-
Well, you are probably on the right track since I would assume that there is a potentiometer that might have a mis-aligned gear on the shaft that needs to be corrected.
Perhaps there are details in the manual about this? http://bit.ly/1bnabX7 (http://bit.ly/1bnabX7)
It is a great game, so I wish you solve this issue.
By the way, I think that this question shouldn't be in the Monitor/video section, but that would be something that the admins could correct.