Build Your Own Arcade Controls Forum
Main => Audio/Jukebox/MP3 Forum => Topic started by: Z0MBIE on November 04, 2013, 09:13:17 pm
-
What's the procedure to reset the error codes in a Rowe cd-100h jukebox?
-
clering error/warnings from memory
1 enter service mode
2 press 6
3 press 1
4 press popular it will blink at u
note
if already in service mode ,or u want to start over,hold reset switch and
repeately press popular until display shows service mode,then start at step 2
that is right out of the trouble shooting guide
ed
-
Thanks! but keeps coming back to error 53
-
error code 53
outer cam switch always open
meaasage means
mechanism control thinks a switch is not working
proable cause
1 a switch
2 a short or open
3 the mechanism control
ed
-
ya, I tested it with a continuity tester and is working so for s&g i disconnected it cleared codes again and now code 50 comes up first.
-
error code
50,51,52,53
50 inner cam switch always colsed
51 inner cam switch always open
52 outter cam switch always colsed
53 outter cam switch always open
ed
-
hmmm that plastic cam is holding the inner switch closed.
-
wind the cam back
so as to realse the switch
see if the control boards makes it enguage again ?
if so u are looking at the error to posts down
mech control board
ed
-
I'm unable to move the cam in either direction with my fingers.
-
power unit down and try
if not remove mech from machine
take it apart to point where u can do it
soory bud but the errors codes do not lie
ed
-
Tomorrow's project will let you know. Thanks!
-
Update- it turns out the shaft on top was seized so I had to take that out and clean it up and lube and put back in. So now it will put on a cd and play but you can't hear it really unless you put your head right to the subs. I can hear the amp is on and hissing when I crank the volume up. I even tried putting the whole thing into another jukebox but get the same. Could a bad laser cause this? :banghead: