Build Your Own Arcade Controls Forum
Main => Main Forum => Topic started by: cigardude on October 15, 2013, 11:20:09 pm
-
Hi everyone. I've been searching for some 1/4" t-molding but no luck. Has anyone ever used it before? Do you have any other suggestions to finish the edges?
-
How about something like GRE34078A (http://www.alliance-express.com/pvc-grommet-edging).
(http://www.alliance-express.com/set-ap/images/series/full/61730_GRE_P_1_L.jpg)
Scott
-
I would just get some regular and follow any one of the methods opn this site for trimming. The sharp chisel seems to be the most popular, but I have had luck with a veneer trimmer tool that only does one side at a time that is available at home depot for $7.
-
My understanding is that they only sell .5" to 1.5" sizes. I've never heard of anything as small as 1/4". If its possible I would get 1/2" material for your build. If you have already built your machine I would have to agree with eds. But keep in mind if you go with a trimmer you won't have a smooth rounded edge. It will be noticeable when you trim it.
-
Use a round over bit with your router.
-
the biggest problem i would see with using t-molding on 1/4" wood is once you cut the slot, there would be hardly anything left. most T-molding i've seen uses a 1/8" slot cutter, that would leave only 1/16" of wood on either side of the slot, which i can't imagine would be strong enough to hold up to anything. I'd either look for a some type of glue on molding, or just use a round over bit on it.
-
the biggest problem i would see with using t-molding on 1/4" wood is once you cut the slot, there would be hardly anything left. most T-molding i've seen uses a 1/8" slot cutter, that would leave only 1/16" of wood on either side of the slot, which i can't imagine would be strong enough to hold up to anything. I'd either look for a some type of glue on molding, or just use a round over bit on it.
1/8" slot cutter? Maybe for the run of the mill stuff you can find in the hardware stores, but I'm pretty sure the norm is 1/16 in this hobby.
Another option would be the stick on pin striping you can find in the automotive store, they may have something in that thickness and I bet if you seal the edge of the mdf/wood it will stick nicely and for a long time.
-
3/32" is the official size. Although quite a lot of people use 1/16" because you can get that size at Harbor Freight. If you use 1/8" you might have to glue the stuff down depending on which tmolding you end up with.
-
Use a round over bit with your router.
I agree and make sure to seal the edge with thinned wood glue or bondo so that the paint does not fade over time or gets fat.
-
you guys are right, my bad...it is a 1/16" slot, but that is still a significant portion of the 1/4" wood. i wouldn't want to weaken it that much.
-
Use edge banding instead of t molding.
Its even sold at home depot and a perfect way to seal the end of plywood.
Applies easily with a clothes iron and thin enough to be trimmed with a small plane or even a razor blade/exacto knife.
-
Thanks for all of the great advice everyone. I think that I am just going to bite the bullet and make the sides and control panel from 1/2" wood so I can just stick on some regular T-Molding and call it a day.