Build Your Own Arcade Controls Forum

Main => Main Forum => Topic started by: mushmouth on November 18, 2003, 10:21:15 am

Title: Upright Pac cabinet CP measurements?
Post by: mushmouth on November 18, 2003, 10:21:15 am

If anyone has ready, easy access to an upright Pac cab, would you be so kind as to run your tape measure across the CP and take down the measurements? The Gods will reach down and smooch you on the mouth in appreciation. :)

mushmouth

Title: Re:Upright Pac cabinet CP measurements?
Post by: General Zod on November 18, 2003, 04:23:11 pm

Greetings ,

These are the specs I came up with.

Hope this helps!

Michael

Title: Re:Upright Pac cabinet CP measurements?
Post by: mushmouth on November 19, 2003, 01:09:59 am

Thanks General Zod. It's kind souls like you that make this board a beautiful place to frolic.

*grin*

Title: Re:Upright Pac cabinet CP measurements?
Post by: paigeoliver on November 19, 2003, 01:26:42 am

Also, remember that the last 2" or so of the panel overlaps the glass, so you can't put any controls there.

Title: Re:Upright Pac cabinet CP measurements?
Post by: mushmouth on November 19, 2003, 05:09:27 pm

So you can't mount a 2-1/4 trackball on it?

Title: Re:Upright Pac cabinet CP measurements?
Post by: mushmouth on November 20, 2003, 10:20:57 am

--BUMP (It's an important question)

Title: Re:Upright Pac cabinet CP measurements?
Post by: paigeoliver on November 24, 2003, 03:56:50 am

Quote from: mushmouth on November 20, 2003, 10:20:57 am

--BUMP (It's an important question)

Yes, you can get even a 3" trackball (with plate) on a Pac panel. My first cabinet ever was a Capcom bowling that was a Pac converstion, it had the 3" trackball with plate and it just BARELY fit.