Build Your Own Arcade Controls Forum
Main => Monitor/Video Forum => Topic started by: buzzdennis on May 22, 2013, 07:17:45 pm
-
Hello everyone. New to the forums. Been browsing here and there for a while but never actually posted anything. Anyway, I have an issue I'm hoping someone can help out with.
I just picked up a sweet capcom impress candy cab. The thing has an mvs single slot board inside and it all turns on just fine. I can play it but where I'm having an issue is with the monitor. The horizontal width is too large and there's a bit of pincusioning going on.
I've done a bit of research on the tube, the chassis and the flyback so I at least understand the basic principles behind the way this monitor works. The remote has a horizontal width adjustment but when I move it, it still is unable to bring the picture to within the limits of the monitor frame. Still too wide. So I'm wondering if there's a horizontal width coil on the board or a pincusion knob that I'm not seeing that could be adjusted. If there are no knobs/pots to adjust, what's my solution to fixing the problem?
Below is a picture of the chassis in question (More pictures upon request). To my knowledge, from research on other forums and neo-geo.com, it's a Hitachi brand but has no Hitachi markings on it, at least none that I can make out. If anyone could give me some insight on possible solutions, I would be so grateful.
-
could be a cap,which one i do not know
a schematic would help
-
Pages 18-22 would be very helpful if they were in English. But they are in Japanese. The last page has a schematic though.
http://wiki.arcadeotaku.com/images/f/f5/Capcom_Impress_Manual.pdf (http://wiki.arcadeotaku.com/images/f/f5/Capcom_Impress_Manual.pdf)
-
the last page is the wirring diagram
thats a 29" unit ? as it call's for ?
ed
-
Jesus, that must've been fun taking out. By remote, you mean the one inside the cp, right?