Build Your Own Arcade Controls Forum
Arcade Collecting => Restorations & repair => Topic started by: ktsest on May 17, 2013, 12:14:04 pm
-
I just picked up a Grayhound Skill Claw and have been reviving it slowly. Problem is, it appears dead in the water. I've got the right voltages out from the power supply and the digital readout fires up ok and reads the EPROM date. Nothing happens in the test mode. I do have a broken capacitor on the coin mech. microswitch, but I doubt that would keep it from doing the test? Could this be the Z80 processor? Would that be a likely candidate? Any troubleshooting help would be appreciated!!
karl