Build Your Own Arcade Controls Forum

Main => Monitor/Video Forum => Topic started by: timply on February 13, 2013, 05:09:44 pm

Title: (Betson) Kortek Zoom option.
Post by: timply on February 13, 2013, 05:09:44 pm

I have a (Betson) Kortek KT-2914F and it has a zoom option on the OSD and was wondering how its used properly when trying to setup your display. As far as I can recall the factory default wasn't 0. I just wanted to get the zoom right before trying to setup the v and h size. Thanks.

Title: Re: (Betson) Kortek Zoom option.
Post by: MonMotha on February 13, 2013, 05:31:18 pm

Modifying "zoom" is the same as modifying both "h-size" and "v-size" at the same time.  If you peg it at one extreme, you may run into another extreme on the size control and have to iterate, but there's no real harm in that.

Title: Re: (Betson) Kortek Zoom option.
Post by: timply on February 13, 2013, 10:18:59 pm

So in other words its best to set it somewhere in the middle and go from there? I'll give it a shot! Thanks.