Build Your Own Arcade Controls Forum
Main => Main Forum => Topic started by: redfivexw on December 26, 2012, 05:21:06 pm
-
I got a 2019 in 1 board the other day, i wired it up with the atx power supply to an LCD monitor. I dont get any response from the controls, however. I can see the picture and it looks like it should work, but no controls work. Do i need to wire up the regular switching power supply as well? I have never used these boards so i am unfamiliar with the requirements, anybody have one of these?
-
yeah i have a few,its probably down to your switch common
are you using a standard jamma loom?
-
yes,
it is a fully populated jamma harness. right now i have the board running off the atx supply, it powers up and comes on screen. I have the jamma harness connected, but i did not hook up the power leads from that harness, i was not sure if it needed them. I have wired many cabinets, so i know how to wire, but not sure if it needs the power leads hooked up.