Build Your Own Arcade Controls Forum
Main => Monitor/Video Forum => Topic started by: BC_Jeffro on November 28, 2012, 04:10:04 pm
-
just picked up a fighting vipers deluxe from 1995 (free) with a Mitsubishi projection monitor vs50se1 that has had a virtual strikers 2 put in
the VS2 board works kinda not all leds were on and had picture but was all green
there was also a jamma harness in the cab so i witched to that but i cant get it to sync
the RGB and the ground and sync are hooked up right
-
the beast
known working S buster bros test has sound plays but out of sync
is this a med rez monitor?
-
yeah wrong resolution,you can see 2 images
i am pretty sure these were 24khz only monitors
the bnc connectors go to a circuit board in the front unit-i do not remember if these were a decoder or just some kind of signal/sync splitter
-
i think you are right it is a 24k only
thats way the VS2 board worked and jamma did not
Thanks!
-
and the board in the front unit dose not covert :hissy:
and all the converter boards out there (within reason there are some pricy ones) only output at 15k sure they will take any 15-31k but only output 15k threw RGB