Build Your Own Arcade Controls Forum

Main => Software Forum => Topic started by: RedSquirrel on October 16, 2003, 06:50:34 am

Title: mamewah/ipac prob?
Post by: RedSquirrel on October 16, 2003, 06:50:34 am

Okay using mamewah (latest version) and for some reason pressing my coin 1 and coin 2 buttons wont do anything. coin 2 is supposed to change emulators, but it doesnt do anything. In the mamewah docs it says that you can use buttons 4 or 6 to change emu. Pressing 6 on my keyboard does nothing, but button 4 does change.

So i thought id try re-programming the ipac  - and loading the ipc file into mamewah. didnt do much though.

I also wanted to change some of my admin buttons to esc and pause etc but again no luck.

Any advice guys? thanks

Title: Re:mamewah/ipac prob?
Post by: Minwah on October 16, 2003, 01:10:34 pm

Which version of MAMEWAH are you using?  Sounds like you are reading the old readme if not using an old version...

Since v0.95b, only coin 4 is mapped to cycle emulator.  Go into Control Options > Customise Controls and just set it to '6' instead :)

Title: Re:mamewah/ipac prob?
Post by: RedSquirrel on October 16, 2003, 06:04:49 pm

Quote from: Minwah on October 16, 2003, 01:10:34 pm

Which version of MAMEWAH are you using?  Sounds like you are reading the old readme if not using an old version...

Since v0.95b, only coin 4 is mapped to cycle emulator.  Go into Control Options > Customise Controls and just set it to '6' instead :)

Thanks ill do that! I must have been reading an old version.