Build Your Own Arcade Controls Forum
Main => Monitor/Video Forum => Topic started by: KonkeyKong on October 27, 2012, 05:21:02 pm
-
Hopefully pictures soon - camera charging.
My son and I were rotating the 29" monitor on a Nanco Exceleena Red candy cab when I heard him say "oops". A cable got snagged and the pins got pulled out of a molex connector. The intact connector that is attached to the monitor has 5 wires: yellow, black, green, gray white, in that order. The gray and white wires run to one connection point on the monitor board, while the yellow, black, and green wires run to a second connection point further away on the board.
The cable that got pulled comes from the cab and only has 4 wires: yellow, gray, white, purple, order unknown on the pulled end.
Everything was progressing quite smoothly until this literal snag. Any assistance would be extremely appreciated.