Build Your Own Arcade Controls Forum
Main => Monitor/Video Forum => Topic started by: Hammerfist on October 19, 2012, 11:12:42 am
-
Hi guys. My cab has the mentioned monitor and it has started to act up. When I turn the cab on and the picture appears, the picture is usually a bit to the right. This goes away in about 10 seconds. In addition to that, from time to time, the screen jumps around from top to bottom (looking from horizontal angle) and then gets back to normal. This has been happening only for two days now, but I'd rather be early with this, than late.. Where should I start, what should I check first? Kind of new with monitors, but not with electronics, so I'm all ears. And yeah, I've read the instructions for how to discharge a monitor (a few times), but I've not done it yet. Thanks!
-
a cap kit and ney flyback are a must.
also a reflow of the chassis and the neck board are a must wile you have it out.
if you need parts PM me or if you need it repaired i can do it for you.
Peace
Buffett
-
a cap kit and ney flyback are a must.
also a reflow of the chassis and the neck board are a must wile you have it out.
if you need parts PM me or if you need it repaired i can do it for you.
Peace
Buffett
Thanks Buffett! I have to check where I can get the parts easiest, but since I live in Finland, the shipping costs might be too big if you would send them. Have you sent parts to europe before?
-
no i have never shipped parts over seas before sorry.
i hope you can find them and not have to pay out the nose to ship them.
but i can help you get it fixed when you get the parts.
Peace
Buffett
-
no i have never shipped parts over seas before sorry.
i hope you can find them and not have to pay out the nose to ship them.
but i can help you get it fixed when you get the parts.
Peace
Buffett
Great to hear. I'll get back to you later. Thanks!