Build Your Own Arcade Controls Forum

Arcade Collecting => Restorations & repair => Topic started by: DLinkOZ on October 15, 2012, 02:38:02 pm

Title: Nintendo VS with both center and off-set molding?
Post by: DLinkOZ on October 15, 2012, 02:38:02 pm

I picked up a nice VS cabinet, internal electronics gutted but externally complete (coin door, bezel and marquee plus hardware, control panel, etc).  I pulled the left side molding, saw it was offset and placed an order.  After pulling the right side, it's standard center-aligned t-molding.  Has anyone seen this?  It's one of the later cabinets, built with the panels within slots routed into the side pieces.