Build Your Own Arcade Controls Forum

Main => Main Forum => Topic started by: the_gamer on October 11, 2012, 01:08:55 pm

Title: IPAC-Software print=left shift?
Post by: the_gamer on October 11, 2012, 01:08:55 pm

I just set up my control panel in the I-Pac-software and wanted to take a screenshot of it to print it out.
But only 1SW4(left shift) is lighting up...

I can take the screenshot with software but I think this behaviour is rather odd. Why is print and left shift the same button for the ipacsoftware? Will the IPAC sent print when i press left shift? I also saw that it wrote unknown when assigning "<". But I guess that is no issue?

Perhaps Andy can clear this up? Any thoughts?

Title: Re: IPAC-Software print=left shift?
Post by: AndyWarne on October 12, 2012, 01:19:02 pm

Hi,

I am not sure I fully understand your question but it might be better discussed by email. Can you drop me an email:

andy@ultimarc.com